How to install a stick-on mirror without bubbles

Stick-on mirrors fall off, or trap bubbles, for the same few reasons: a dirty surface, a cold day, or pressing only in the middle. Ten careful minutes avoids all three.

What you need

  • Rubbing alcohol (isopropyl) and a clean, lint-free cloth
  • A strip of masking tape, to mark the spot
  • A mild, dry day. Adhesive pads grip poorly on cold or wet glass. If the packet gives a temperature range, follow it.

Four steps

  1. Clean and dry the glass. Wipe the spot with alcohol, not window cleaner, which can leave a film. Let it dry completely.
  2. Find the spot before you peel. Sit in your normal driving position and hold the mirror where you plan to put it. Mark one edge with masking tape so you can find the spot again.
  3. Peel, set one edge, then roll it down. Touch the outer edge to the glass first and lower the rest like closing a book. This pushes air out instead of trapping it. Then press firmly across the whole face for about 30 seconds, edges included.
  4. Aim it, then leave it alone. If it has a swivel base, tilt it now. Keep it dry and skip the car wash for a day while the pad bonds.

If you get a bubble

A bubble under a foam pad is usually just air under one edge. Press from the middle of the mirror toward that edge to push it out. If the pad itself is creased or has picked up dirt, it won't hold for long; replace the pad instead of pressing harder.

Stuck it in the wrong place?

  1. Warm the mirror gently with a hair dryer for a minute to soften the pad.
  2. Slide dental floss or fishing line behind it and saw through the pad. Don't pry with a blade: side-mirror glass can crack.
  3. Roll the leftover adhesive off with your thumb, then clean with alcohol.
  4. Use a new double-sided pad to stick it again. The old one won't hold a second time.

Heated mirrors are fine with stick-ons, but keep the hair dryer moving and warm, not hot.